Wera 074842-010 Custom Pre-Set Fixed Torque ESD Screwdriver, 1.2 – 3.0 Nm

Details

Wera 074842-010 Custom Pre-Set Fixed Torque ESD Screwdriver, 1.2 – 3.0 Nm

For any application where the same constant torque and repeat accuracy are required
ESD construction for safe protection against electrostatic charge and associated damage.
Desired fixed torque setting can be specified in the following units: Nm, kgf. m, lbf. ft., ozf. in., dN. m, kgf. cm, lbf. in, in. oz, cN. m, gf. m, ft. lb, gf. cm, in. lb.
Fixed value can be easily adjusted between 1.2 and 3.0 Nm using Wera’s Recalibration Kit and any appropriate torque tester
Rapidaptor technology for rapid 1/4″ hex bit change
Distinct signal when pre-set value is reached
Multi-component Kraftform handle for high working speeds
Unlimited counter-clockwise torque for loosening stuck screws
Handle length: 105 mm
Total length: 155 mm
Manufacturer’s part number 05074842010

Note: this screwdriver is pre-set at the factory and requires a specified torque value at the time of ordering.Handle Material:Multi-Component Material